Introduction to common faults and troubleshooting methods of vermicelli machine

Now, many large-scale vermicelli processing factories have chosen automated vermicelli production lines, but if they encounter some minor problems, they are not clear how to judge and solve them, resulting in shutdown, which delays the progress of processing. Let me briefly explain the common faults and troubleshooting methods of pulp-spreading vermicelli processing equipment.
Fault 1: The temperature of the drying system of the vermicelli machine is low
cause of issue:
1. The steam pressure is low and the temperature does not go up. This situation requires an increase in boiler steam pressure.
2. The thermocouple or temperature indicator is faulty. At this time, the thermocouple and temperature meter should be checked first to ensure that the thermocouple and temperature meter are in normal use.
3. The radiator leaks steam. Check for leaks, and weld the leaks if necessary.
4. The hot air duct is blocked. Check the machine to find the blocked part and unblock it.
Fault 2: The steel belt of the vermicelli processing equipment goes off track
cause of issue:
1. The tensioning screw rod is not adjusted correctly, just adjust the tensioning screw rod correctly at this time.
2. There is a deviation in the parallelism of the two rollers and the support roller, and the position of the roller and the support roller should be adjusted correctly in time.
Fault 3: When the speed regulating motor is working, the speed keeps rising, and the adjusting knob is out of function
cause of issue:
1. The potentiometer is damaged. Check and replace the potentiometer in time.
2. The pins are in poor contact. In this case, the pins can be cleaned with alcohol.
3. The diode burns out during operation. The diode should be checked and replaced in time.
Fault 4: The mesh belt of the vermicelli processing machine goes astray
cause of issue:
1. The tensioning screw is not adjusted correctly. At this time, the tensioning screw should be adjusted correctly.

2. The axes of the two steel rolls are not parallel or misaligned. First, correct the horizontal position of the two steel rolls, and then adjust the offset to make them align.