Use and maintenance of automatic noodle machines

1. Put the noodle press on a level ground, keep the frame balanced, and do not need to fix the feet.
2. Turn on the power to make each drive reach the required rotation direction.

3. Keep the center of the roll of the noodle press relatively positive, and the maximum deviation is ±3mm.

4. The leaf thorns in the dough bucket replace the manual mixing machine, and should not be removed at will. The dough should not be added to the dough bucket without excessive compaction. It is strictly forbidden to directly enter the dough bucket and mix the dough by hand during operation.
5. When using, it is strictly forbidden to drop other objects into the pressure roller and gear to prevent damage to the machine. The residual surface of the part must be cleaned up for each shift.
6. The cutter must be cleaned frequently. If wrinkling is found, the comb can be adjusted to make the comb close to the face knife and the root of the knife groove.
7. When replacing the comb blade, the front section of each tooth of the comb blade should be trimmed into an acute angle, and the comb blade should be pressed tightly without gap when it is installed into the face knife straight with the bottom surface.
8. If it is found that there is excess surface on the pressure roller, the scraper on the pressure roller should be adjusted.
9. It is forbidden to put dry noodles into the machine for heavy pressure, and it is forbidden to put the newly pressed long noodles into the machine for heavy pressure without being crushed.
10. Always check whether the nuts are loose.
11. After the work of each shift, all remaining surfaces on the machine should be cleaned up to avoid damage to the pressing roller and the comb of the dough cutter before the next startup.

12. During the noodle pressing process, if any abnormal sound is found, the machine should be stopped immediately for inspection. After the cause has been investigated and properly dealt with, the production can be resumed. If the organic parts are damaged or the cause cannot be found, the manufacturer or sales department should be notified immediately. Users are not allowed to change without permission. On-site (including the remaining surface that has not been pressed on the machine), so that the relevant personnel can analyze and identify the cause of the accident. For example, the user disassembles the machine without permission to change the site, so that the maintenance personnel cannot analyze.