Precautions for using vermicelli machine

Precautions for using vermicelli machine

1. When operating vermicelli electromechanical heating, pay attention to the evaporation of the water level in the water tank at any time to prevent the lack of water and cause damage to the electric heater. When the water temperature reaches 90-100 degrees before production, you can temporarily turn off the electric heater to maintain the water temperature. Reduce power consumption, and start the electric heating tube after the pre-production preparations are completed.

2. After daily use, it is necessary to open the drain gate to release the water in the water tank to prevent freezing. Before going to work, add cold water or hot water. It is not easy to add too much water to cover the 2-3 cm above the main shaft immediately. When working, refill the water once a shift.

3. Before each shift of the vermicelli machine, a small amount of edible oil should be applied to the tee pipe, the bottom of the sieve, the inside of the bearing sleeve and the screw shaft, and then installed in sequence, and then started to work. After each shift, the machine needs to be loosened. Every screw thread in the head part is locked to prevent aging and cannot be disassembled.

4. When abnormal noises are found during work, stop the machine for inspection in time.

5. When operating, pay attention to safety and prevent any unsafe accidents.

6. The installation and use of electrical appliances shall be carefully operated in accordance with the regulations on safe use of electricity.

7. After the bearing has been working for 200-300 hours, it needs to be disassembled and added with grease.