Daily operation of automatic noodle machine and how to solve problems encountered？

Daily operation of automatic noodle machine and how to solve problems encountered？

1. Kneading the noodles: Pour the flour into the noodle mixer, then add water according to the prescribed ratio of about 25%, start the capacity, mix the noodles and water evenly to a granular shape (the best use after 10 minutes), and it is ready to use.

2. Adjustment: Adjust the roll gap with the handwheel. The reference data of each group of roll gaps are: (except for units above 330) During the adjustment process, it is sometimes difficult to adjust or loosen the handwheel at one time. The key is to Find out the reason, grasp it patiently, stop the adjustment when you are not proficient, and lock the handwheel when it is normal.

3. Operation: Put the mixed flour into the flour bucket, press the knife and fix the knife plate, and then start the operation. The panel from the third group should be guided to the next group by hand (and so on for multiple groups). The operation is completed. .


Noodle machine common problems and troubleshooting methods:

1. The panel of the noodle machine cannot be connected normally: due to improper adjustment of the roll gap, there will be broken plates and excess plates. For example, the previous panel is thin, the next panel is thick, and the demand for the next one is large, so the plate will be broken, and vice versa. For this reason, when adjusting the roll gap to break the plate, reduce the gap between the next set of rolls to make it even.

2. The running edge of the panel of the noodle machine or the uneven thickness on both sides of the panel: it is caused by the inconsistency of the gap between the two ends of the roller, so adjust the gap between the two ends of the roller to make it even.

3. The panel and noodles of the noodle maker are in a curved shape: the scraper between the rollers and the cutter comb should be adjusted to the right position if the installation angle is too large or the edge of the comb is reversed.

4. The panel of the noodle machine is dipped in the roller: it is because the surface is bad and the moisture is too large or the scraper bolt is loose.

5. Noodles are broken: because there are impurities in the flour (residues left in the last mixing bucket) or the dough is not evenly mixed.

6. Cut continuous noodles: the blade of the cross-section does not match the bottom plate, and the blade of the cross-section can be adjusted to the correct position.